Home / Products / DTH Tools / DHD360A DTH Hammer
DHD360A DTH Hammer
DHD series · without foot valve · hole range Φ158-203 mm
Structure · Parts list
Numbers match the sectional view above | 15 parts in total
| No. | Part | Weight | Part No. |
|---|---|---|---|
| 01 | Top Sub | 21.5kg | 01-DHD360A-01 |
| 02 | O Ring | 0.01kg | 01-DHD360A-02 |
| 03 | Disc Spring | 0.34kg | 01-DHD360A-03 |
| 04 | Check Valve | 0.56kg | 01-DHD360A-04 |
| 05 | Spring | 0.05kg | 01-DHD360A-05 |
| 06 | Valve Seat | 4.3kg | 01-DHD360A-06 |
| 07 | Inner Cylinder | 4.2kg | 01-DHD360A-07 |
| 08 | Piston | 23kg | 01-DHD360A-08 |
| 09 | Outer Cylinder | 36.5kg | 01-DHD360A-09 |
| 10 | Guided Sleeve | 6.3kg | 01-DHD360A-10 |
| 11 | Check Ring | 0.02kg | 01-DHD360A-11 |
| 12 | Stop Ring | 1kg | 01-DHD360A-12 |
| 13 | O Ring | 0.01kg | 01-DHD360A-13 |
| 14 | Drive Chuck | 8.2kg | 01-DHD360A-14 |
| 15 | Drill Bit | — | 01-DHD360A-15 |
Product description
The DHD series is one of the most widely used DTH hammers: mature design, readily available spares, and direct compatibility with most rigs and bits. Suited to medium-hard to hard rock in water wells, mining and blast holes.
A DTH hammer is a piston-type air tool: compressed air enters through the top sub, opens the check valve and is routed by the valve seat to drive the piston back and forth in the inner cylinder; the piston strikes the bit shank and the energy breaks the rock. Exhaust leaves through ports in the piston case, and flushing air carries cuttings out of the hole. The drive chuck transmits rotation, while the stop ring and guided sleeve keep the piston stroke and alignment.
Selection guide: OD Φ148 mm, hole range Φ158-203 mm, thread API3 1/2″REG, matched with DHD360A bits; recommended working pressure 1.2–2.5 MPa, air consumption 16 / 23 m³/min. Use the upper pressure in hard rock and reduce it in wet formations to avoid regrinding cuttings.
Suitable for water wells, bench blasting, quarries, geothermal drilling and foundation anchoring in medium-hard to hard rock. Bits, subs and packaging can be customized to drawing or sample; standard models are in stock and bulk lead times are confirmed on order.
Technical parameters
Whole-unit parameters | air consumption at 1.0 / 1.5 MPa
| Model | DHD360A |
| Type | without foot valve |
| Outer Ø | Φ148 mm |
| Hole Range | Φ158-203 mm |
| Length (less bit) | 1210 mm |
| Weight | 106 kg |
| Thread | API3 1/2″REG |
| Bit shank | DHD360A |
| Air pressure | 1.2–2.5 MPa |
| Air consumption (1.0 / 1.5 MPa) | 16 / 23 m³/min |
